Banggood 에서 세일하던 H8 mini 를 받아 잠깐 테스트 해봤는데 조종법이 이상했다..
알고보니.. Mode1 이라고 판매한게 Mode 3 였음..
그래서 조종기를 개조했
프롭가드는, 탈거가 불가능해서
나중에 니퍼로 잘라내면 될것 같고..
백홈기능은 지멋대로라 안씀 ㅎㅎ
러더감도는 상상을 초월 ㄷㄷㄷ
팽이를 만들수 있다 ㅎ
카테고리 없음2015. 7. 13. 15:22
카테고리 없음2015. 7. 10. 15:45
|
Tips for settings (not via computer):
Tip1: Adjust your transmitter end point from the original 100% to 120%.
Explanation: The lowest signal flight controller can receive is 1095, median is 1500, and the highest at 1950. This may differ from each different transmitter manufactures, so we directly increase 20% to ensure that the control signal will exceed 1095-1500. If your signal is not more then it will cause it to not start.
In my Futaba T12FGH, for example, I need to adjust it to 110% then I am able to smoothly start the motor.
Tip2: reconfirm your CH1-CH4 and your receiver is connected correctly.
Tip3: Try Arming the motor while it is without any propellers.  If you can not successfully start the motor, then the only possibility is that you need to set CH3 & CH4 to reverse in the transmitter. This time try the left joystick in all four directions. If you’re able to successfully start the motor, then set CH3 or CH4 in accordance with the direction in reverse.
Tip4: After installing the propellers, start the motor. Carefully hold the aircraft in hand, gently push the control stick to the right. Confirm that the aircraft is moving in the same direction. If not, please enter the transmitter control to set CH1 or CH2 to reverse.
In my Futaba T12FGH for example, Ch2 and Ch3 need Reverse.
Tip5: before the first flight, you can calibrate according with the following picture.  If you still can’t succeed in the manner described above, please follow the instructions below. (Requires connection to computer)Follow these steps:
1. Connect the flight controller to computer, install USB driver (CH340), usually the computer will automatically install, in case it doesn’t start automatically. Please manually search for "CH340" to install the driver; Tips: Check your computer port if CH340 is working properly after installation.
Driver Download: CH341SER.EXE This controller is using NAZE32 6DOF, you can use the following two softwares.
|
| This article was published on Wednesday 10 June, 2015. |
카테고리 없음2015. 7. 8. 10:30
